1 Channel PoE

Maple Leaf Facility Solutions Inc.

1 Channel PoE

Shipping calculated at checkout.

1 Channel PoE

1 Channel Power over Ethernet injector

POE-1HP is a low cost
1-Port High Power midspan injector. It is
functionally compliant to the IEEE802.3af
standards. This midspan injector can
fully provide 36W per port over Cat5e/
Cat6 cables into 10/100/1000 Base
T systems, eliminating the need for
power management and prioritization.

 

APPLICATIONS

Security Camera with Pan/ Tilt/ Zoom IP Print Servers

FEATURES

Fully Compliant with IEEE802.3af 10/100/1000 base T compatible; Full ProtectionOCP, OVP
Full Power of 15.4W per port Cisco AP1250 Full Power Support; rack mount possible
Cisco: no extern parts required for Legacy devices: VoIP Phones (7910, 7912, 7940, 7960)
Access points (350, 1100, 1200)

SAFETY

Isolation Test Primary to Secondary: 4242VDC for 1min. 10mA, Primary to F.G.: 2121VDC for 1 minute, Output to F.G.: 2121VDC for 1 minute
Insulation Resistance Primary to secondary: >10M OHM 500 VDC, Primary to F.G.: >10M OHM 500 VDC

OUTPUT

DC Output 56V @ 15.4W per port
Regulation Functional requirements of IEEE802.3af

INPUT

AC Input Voltage Range 90 to 264 VAC
Leakage Current 3.5 mA max @ 254 VAC 60 Hz
AC Input Frequency 47-63 Hz
AC Inrush Current 30A(RMS) max. for 115VAC/ 60A(RMS) max. for 230VAC
AC Input Current 2.5A for 90VAC / 1.3A for 240VAC

GENERAL

Efficiency 75% (typical) at max. load and 120VAC 60Hz
Hold-up Time 16mS min. 120VAC and max. load
Transient O/P Voltage Protection 60V max. at switch on and off at any AC line Phase
Turn-On Delay Time 3 sec max. at max. load, and 120VAC 60Hz, 25Hz
Regulation Functional requirements of IEEE802.3af

EMC

Conducted & radiated Emission EN55022 Class A, FCC Class A with UTP Cabling
EN55022 Class B, FCC Class B with FTP Cabling
Immunity EN50082-1 ESD EN61000-4-2. Level 3
RS EN61000-4-3. Level 2
EFT EN61000-4-4. Level 2
Surge EN61000-4-5. Level 3
CS EN61000-4-6. Level 2
Voltage Dips EN61000-4-11
Harmonic EN61000-3-2 Class A

ENVIRONMENTAL

Temperature Operation 0 to +40°C, Non-operation -25 to +65°C
Humidity Operation 5 to 90%